A little bit of water is coming out of the top spinner but it doesn't spin. We have hard water and I'm not sure what to try. My husband would like to just chunk it and get a new one but if there is just a clog or a part that might need to be replaced I would like to try it first. The bottom seems to be working fine it is just the top spinner. It's a Kenmore model 587.15152400. The top spinner arm is not working.We have hard water and I was just wondering what are some things I can try.
The two spray arms will never operate at the same time, they alternate. I added the theory of operation in the image below so that you will have an understanding how it alternates spray arm operations.This alternating of the spray arms is achieved with a check ball located on a ramp between two outlets of the pump. There is an outlet to the bottom spray arm and an outlet to the upper arm delivery tube. In the normal position the ball is at the bottom of the ramp, in front of the opening to the upper arm delivery tube. When the pump starts, the force of the water pushes the ball to block the opening to the upper arm delivery tube.Not all of the water is blocked however. The opening is constructed to allow a small amount of water to bypass the ball and enter the tube, and fills the tube at a rate of approximately four inches a second. At the same time, the outlet to the lower spray arm is open, so the lower spray arm operates. When the pump stops, the pressure is removed from the ball and the water flows down the tube, forcing the ball up the ramp and against the outlet to the lower spray arm. If the pump remains off for more than 3 seconds, all the water in the tube escapes and the ball returns to the bottom of the ramp. But, if the pump is started in less than .6 seconds, the water from the upper arm delivery tube is still forcing the ball up the ramp against the outlet to the lower spray arm. The force of the water from the pump continues to hold the ball against the outlet to the lower spray arm which leaves the outlet to the upper arm delivery tube open. When the ball is in this position only the upper spray arm operates. This momentary stopping of the pump is controlled by the timer.So, if the ball is stuck, it will not shift to the upper spray arm. I recommend removing the filter and the volute and check to see if the ball is stuck.
Ready to buy what you need?Shop now
Still have questions?Ask us
Need expert repair service?Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”