Ask a question

ask it

58,949

FIND ANSWERS QUESTION ASKED
Get it Done

, Share, Email or Print  question and all answers.

This question is open

What should I replace on my treadmill that is getting a e21?
All the diagrams look like what I've got but the flow diagram seems like its for a different controller. I do not have the 120v LED lit but I can read120v at ac1 and ac2 on the controller board (which means I am reading the 120v input and output on the power supply and the thermal switch on the motor.) In the test mode, my PWM LED flickers with increased speed but I do not seem to have voltage from the power supply to the motor controller on L, W and H.

Asked by hoolie31 about about 1 month ago

(1 expert, 0 community answers)

Expert Answer

  • rate this answer
  • rate this answer
  • rate this answer
  • rate this answer
  • rate this answer
(0 ratings)

Answer by:
Mark T. - Personal Solutions Manager, about about 1 month ago

I forgot to mention that the flow chart was intended as a rough guide. My fault. The mc70 motor control produces 5 volts dc that it feeds to the power supply board. Then the power supply will feed a metered portion of that voltage back to the motor control depending on the speed selected. If you have the required 120 vac to the motor control and 0 vdc out I recommend replacing the motor control.

Print answer.
Rate answer
Not helpful
  • Currently 0/5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
Helpful

Community Answers (0)

View:
Get it Done