how do i program remotes and keyless entry on a gaurge door opener?
I changed my battery on my gaurage door opener remote control and programmed it. once i did that my other remote and keyless entry stopped working. everytime i program one the other stops working.i did follow the steps in my owners manual. how would I program all three so that they all function?
B b g...
Expert
You probably need to erase the codes from the logic board on the garage door opener. The memory of the logic board will store 4-6 codes. If the memory is full it won't accept another code.
Hold the learn button on the garage door opener in until the led goes off. This will erase the codes in the memory of the logic board. It should accept the code of the remotes now. Now press the colored learn button briefly and then press the button on the remote. The lght bulb will flash once to let you know the code is accepted. To reprogram the keypad press the learn button again and then press the 4 digit code you want to use followed by the up/down button. The light bulb will flash again. When you program the remotes, remove the battery from the one you are not programming. Sometimes the remotes fail and won't let the other remote program. This way you will find the bad one if you have one. If these instructions don't work then you have a bad logic board and it needs replaced. You can find one at sears.com Thanks BBJoin this conversation.
Member
Start smart
-
Ready to buy what you need?
Shop now -
Still have questions?
Ask us -
Need expert repair service?
Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”
