July 03, 2009
How do I replace a pull cord on a Craftsman trimmer model 358791070?
How do I replace a pull cord on a Craftsman trimmer model 358791070?
Jimmy k
Expert
Remove the trigger housing on the drive shaft by removing the 4 screws and separating the housing. Make note of how the trigger and the throttle cable mount in the housing
You will need a special tool to unscrew the clutch housing from the clutch assembly. The part number for the tool is 530031112. Remove the clutch housing and the clutch from the engine shaft.Remove the screws holding the fan housing to the engine and remove the fan housing. The rope and the starter pulley are inside the fan housing. Be very careful removing the starter pulley and spring. The spring will unwind violently if it is released. As you install the rope on the pulley, turn the pulley. Let the turning of the pulley wind the rope and it will load the spring so it will retract.Join this conversation.
Member
Start smart
-
Ready to buy what you need?
Shop now -
Still have questions?
Ask us -
Need expert repair service?
Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”
