I hv a Sears garage door opener, the remotes work but the hard-wired button blinks fast but does not
My garage door opener is a Sears Craftsman Lift Master Formula One quite drive. The car remotes/outside battery-operated remote function perfectly, but the hard-wired button as you walk in the garage blinks rapidly but doesn't lift or close the door. I checked to see if the Lock is on but it doesn't appear to be engaged. Any suggestions are welcome.
B b g...
Expert
Most of the time if the wall station blinks rapidly it is locked. Try holding down the lock button for 4 seconds and let go. Did it go steady?
If not take the cover off and take the wall station off the wall and on the back you will see 2 wires to 2 terminals. Loosen them and set the wall station aside. Touch the 2 copper ends together to see if the operates. Don't worry these wires only carry the same current as a nine volt battery. If this works and it still blinks then you need a new wall station. If it does not check the wiring from there to the opener. If still nothing you might need a new logic board. BBJoin this conversation.
Member
Start smart
-
Ready to buy what you need?
Shop now -
Still have questions?
Ask us -
Need expert repair service?
Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”
