November 30, 2008
How do you get your garage door opener remotes to sync back up with the opener when they have been reset?
It is a Craftsman 1/2hp chain drive garage door opener, model 139.53985, serial 14541100085.
Jimmy k
Expert
I assume you changed codes in your remotes. When you do this you need to erase all the codes in the logic board's memory. To erase the codes, hold the learn button in until the led goes off.
After erasing the codes you must reprogram all remotes and the keyless entry if you have one. To program the remotes, hold the button on the remote you want to operate the door in, press and release the learn button and release the button on the remote. To program the keyless entry press and release the learn button on back of the motor unit and within 30 seconds enter the 4 digit code on the keyless touchpad. Hold the enter button in until the light on the opener flashes.Join this conversation.
Member
Start smart
-
Ready to buy what you need?
Shop now -
Still have questions?
Ask us -
Need expert repair service?
Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”
