How can I get my remote control for my garage door opener to program?
I was able to set one remote with the instruction I found in the "ask your question," but wasn't able to set the second remote. The SRT light stayed solid and the light never flashed.
Expert
Maestro
First confirm that the two remotes are the same part number and the buttons on the remotes are the same color. If they are correct, you need to erase all the codes in your logic board. The logic boards will remember a set number of codes.
To erase the codes hold the learn button on the back of the motor unit in until the SRT light goes off, probably about 10 - 15 seconds.
You will then need to reprogram your remote controls.
Join this conversation.
Member
Start smart
-
Ready to buy what you need?
Shop now -
Still have questions?
Ask us -
Need expert repair service?
Schedule now
“This is a great place to go for advice, especially if you're low on funds and you could resolve the problem before calling and paying a service call, if it's an easy fix. I'm glad you are there for me.”
